Similar to recent client changes, don't replace the previous node record
of an already-migrated VM. Wait for shutdown if required. Use a
continue statement instead of a needless else block.
Adds a config flag that turns on the API client following the Primary
coordinator. The retcode of the start/stop commands is ignore so this
can fail gracefully if e.g. the client isn't installed.
This was very old code that was hard to follow and quite fragile, with
failures and infinite loops occurring fairly frequently. These changes
make the code more robust, including the addition of timeouts, some code
cleanup, and some improvements to the logical flow.
Also forces the libvirt migration to occur on the cluster network, which
couples to changes in the libvirtd listen (via pvc-ansible) and in
Daemon.py via the previous commit.
Reference: https://bugs.debian.org/cgi-bin/bugreport.cgi?bug=717215#68
Without this, DHCP fails when traversing only the local bridge, for
Debian Jessie or earlier (and possibly other OSes as well), due to the
missing UDP checksums. This disables the offload and hence reenables
the checksums even on the software-only bridge.
Also rearranged the steps and added comments arround this section to
better clarify what each command is doing.
There was really no need for this to be shared among all the
coordinators, which seemed more fragile. This way only the primary will
try to fence dead nodes.
This seems like a super-gross way to do this, but at the moment
I don't have a better way. Maybe just remove this component since
none of the volume/snapshot stuff is dynamic; will see as this
progresses.
The old way of doing this was a little cumbersome, with an upper YAML
tree split between "devices" (name and MTU) and addresses. This commit
unifies these under the root "networking" section to make this section
clearer.
MTUs were hardcoded at 9000, which breaks if the underlying interface
or network switch does not support jumbo frames, a possible deployment
limitation. This has non-obvious consequences due to MTU mismatches
for certain services (Ceph, Zookeeper, etc.).
This commit adds support for configurable MTUs for each interface,
set in pvcd.yaml. The example has been updated to reflect this, with
a default of 1500 (the Ethernet standard).
This commit also adds autoconfiguration of the VNI device MTU based
on the `vni_mtu` value, the same for bridge networks and minus 50
(rather than 200 from the hardcoded value, based on the following
resource [1]) for VXLAN networks.
[1] http://ipengineer.net/2014/06/vxlan-mtu-vs-ip-mtu-consideration/
1 second was just slightly too little time to wait and packets would
occasionally be lost on primary switchover. Increase this to 2
seconds to provide more time for arping to run on the new primary.
1. Remove a number of time.sleep commands which don't really seem
necessary any longer and which significantly increased the startup
time while parsing the VM list.
2. Handle some variable sets during initialization of the object,
rather than waiting for a management command, enabling...
3. Know when a state change, and the corresponding Libvirt lookup,
is unnecessary due to the target node not matching the current node.
This also removes a number of unremovable errors from Libvirt on the
console which were annoying.
This reduces the total time taken by the VM startup segment (lines
760-762 of Daemon.py) from 17.117s down to 0.976s for 82 VMs.
Joshua Boniface